GENESIS G40: E-MU 0202 Soundcard Wiring Connection

The back of E-MU 0202 Soundcard showing line input. One channel is R-Line and the other channel is L-Line (Pin #2).

The R-Channel is connected through 5mm mono jack and L-Channel is connected by using Amphenol AC-IDC Series Audio cable connector. Cut two 1-metre lengths of shielded cable.

Push the cable through the PVC nut assembly.

Strip the cable back 35-40mm. Twist the shield wire.

Fit the cable into the jaws cable clamp, ensuring that the cable is pushed up to the neck of the clamp.

Pull back the conductors into their individual wire guide tracks. Wire as per photo .Pin 1 is ground, Pin 2 is the Red wire and Pin 3 is the Black wire. No soldering required. Wires attached to pin plug as friction fit. The sharp ends of the pin plug will cut through the PVC insulator and create connection.

Insert the pin plug into housing.

Push the clamp into the housing, ensuring the key ways are aligned.

Close the cable clamp. Push and screw the nut over the clamp into the housing.

For the R-Channel: use the second length of the shielded cable, install 5mm mono jack.

Finally, connect both channels to 3.5mm stereo jack as per photo.

The photo of finished RX cable.

RX Setup connection.

TX Setup connection: Stereo shielded cable with two 3.5mm jacks connected as per photo, E-MU Output Stereo 3.5mm connected to G40 TX connector.

From left to right, E-MU 0202 L-Channel, R-Channel, R+L TX, USB 2.0 to PC USB Port.

Return to G40 homepage

Need help? email: help@GenesisRadio.com.au

©2009. www.GenesisRadio.com.au